Mexican Bathroom Sink #044 installation
Place your oval mexican bathroom sink upside down on the countertop and draw a line around it. Afterwards, draw an additional line about 3/4" inside the outer line. The second one will be used to cut the opening in the bathroom cabinet counter. Drill 3/8" starter hole on the line and begin cutting the the counter top. Then cut the the area between the first and the second oval line in front of the cabinet for the sink over-flow. Drop your bathroom sink into the opening and make the adjustments if necessary. Place plumber's putty around the sink bottom edge of the drain-assembly lip and press the housing into the drain hole. Attach the gasket with a washer and tighten the locknut by hand. Using the wrench is most likely going to damage the sink. if you didn't install the faucet yet turn your mexican bathroom sink upside down and place silicone along the lip. Align the bathroom sink with the countertop edges, press firmly along the lip to form a tight seal. Set your oval bathroom sink in place firmly pressing down to assure adequate contact. Rustica House is not responsible for any damage caused by the direct or indirect use of this article. We recommend consulting a licensed plumber for mexican bathroom sink installation.
|